U2FW-IDE12-FW Bridge Board
|
|
U2FW-IDE12-FW
Supports two IDE (ATA/ATAPI) devices.
U2FW-IDE12-FW is a FireWire (IEEE 1394a) to IDE (ATA/ATAPI) Bridge Board featuring Oxford OXFW911plus FireWire (IEEE 1394a) to IDE Bridge Controller.
Technical Specifications
FireWire (IEEE 1394a) to IDE (ATA) Bridge Board:
- IDE (ATA/ATAPI) Interface: Male IDC 2X20 Connector
- Both ATA and ATAPI devices are supported using the same firmware.
- FireWire ports: External X 2 (FireWire 6pin)
- 1394a PHY: Ti's TSB41AB2 1394a-2000 400Mbps PHY
- 1394 Bus Transfer Rate: 100/200/400 Mbps
- HDD Access LED
- Provides Striping and Spanning function
- FireWire (IEEE 1394a) to ATA Native Bridge Controller: Oxford OXFW911plus
-
Complies with T13's ATA/ATAPI-6 Draft Specification:
- PIO Mode 0 ~ 4
- DMA Mode 0 ~ 2
- Ultra DMA Mode 0 ~ 6
- Supports 48-bit addressing for large hard drives (>128GB).
Above date taken from http://www.ioi.com.tw/spec/cat_101/1010015.htm
Do you have any questions about U2FW-IDE12-FW Bridge Board?
Your Name:
Your Email:
Your Question:
Enter the code in the box below: